EV Meter Installation (Without Junction Box)

NOTE: EV Meter is formerly known as "JuiceStation".

1. Turn off the mains power to the hardwire connections.
2. Use a multimeter to ensure that there is no power at the hardwire connections.

WARNING: Do not continue with the installation until the multimeter shows that there is no power at the hardwire connections to mains.

3. Use a Torx 15H bit to release the fasteners (x10) that secure the rear cover. Set the fasteners and cover aside.
   
4. Ensure that the low voltage connector (black) from the payment terminal screen is plugged into the ethernet bundle (yellow).
5. Place a soft cover on the ground so that the EV Meter is not damaged in the next step.
6. Gently tilt the EV Meter so that it is lying on its front side.
   CAUTION: Ensure that the EV Meter, especially the payment terminal screen, is not scratched.
7. Pull the high voltage and low voltage cable bundles out through the hole in the base of the EV Meter:
   • High voltage bundles (x2): Bundle of green, black, and red wires with black corrugated tubing
   • Low voltage bundle (x1): Bundle of blue, brown, and green wires with yellow shielding

   NOTE: The corrugated tubing is not as long as the wires, and therefore might not protrude through the hole in the base.
   

   1	High Voltage Bundle
   2	High Voltage Bundle
   3	Low Voltage Bundle

8. Splice the low voltage bundle into one of the high voltage bundles:

   	Positive (+)	Negative (-)	Ground
   High Voltage	Red	Black	Green
   Low Voltage	Blue	Brown	Green

NOTE: If necessary, cut the high voltage and low voltage wires and insulation to an appropriate length, depending on the installation.

9. Connect the 2 high voltage bundles to the hardwire connections to mains.
10. Carefully stand the EV Meter up so that it is resting on its base.
11. Reinstall the rear cover.
12. Install the EV Meter onto the ground studs.
13. Install the 2 sides of the base cover around the base of the EV Meter. Use a Torx 15H bit to install the fasteners (x4) that secure the 2 sides of the base cover.
    

    1	Front
    2	Rear

14. Use a Phillips bit to install the self-tapping fasteners (x4) that secure the base cover to the EV Meter.
    
15. Reconnect power to the hardwire connections. The EV Meter turns on automatically.