- Lock out and tag the circuit breaker(s) with a LOTO (Lock Out/Tag Out) kit.
- Remove and discard the 10 fasteners that secure the back plate to the pedestal. Remove the back plate.
- Remove the 4 screws to open the junction box cover within the pedestal.
- Use a multimeter to ensure that wires supplying power to the pedestal indicates a zero voltage, as there may be more than one circuit in the junction box.
Warning: Do not continue with this procedure until the multimeter shows that there is no power at the hardwire connections to mains.
- Inside the CCR kit packaging, locate and open the accessory box and take out the antenna and antenna bracket.
- Route the antenna cable through the hole on the antenna bracket and place the antenna on the bracket.
- Secure the antenna by tightening the nut using 19mm wrench.
- On the top section of the pedestal, you will see 2 mounting points for installing the antenna bracket.
- Install the 2 button head Phillips screws to secure the antenna bracket.
NOTE: It is recommended to apply a torque of 80 in-lbs to the screws.
Search
<% if (previousArticle) { %>
<% } %>
<% if (items.length > 1) { %>
<% if (previousTitle) { %>
<% } %>
<% if (nextArticle) { %>
<%= previousTitle %>
<% } %> <%= previousArticle.title %>
<% if (nextTitle) { %>
<% } %>
<%= nextTitle %>
<% } %> <%= nextArticle.title %>Main sections in this article
-
<% items.forEach(function(item) { %>
- <%= item.name %> <%= partial('partial-table-of-contents', { items: item.children, partial: partial }) %> <% }); %>
-
<% items.forEach(function(item) { %>
- <%= item.name %> <%= partial('partial-table-of-contents', { items: item.children, partial: partial }) %> <% }); %>